How do you fix a staple gun jam?
Clear the jam with needle-nose pliers. Check out the top of the stapler where the staples are discharged. Use the pliers to pinch the staple and pull towards you, pulling the staple out of the stapler’s nose. After that, reassemble the staple gun by putting the magazine back in and screwing in the screw.
How do you fix a stapler that won’t staple?
If unable to shake the jammed staple out, try to staple a single sheet of paper while the unit is jammed. This could possibly force the jam outward, clearing the unit. If this does not work, try using any sizable tool or nearby accessory, try to fish out the jammed staple through the “front teeth” of the stapler.
How do you fix a stuck Bostitch stapler?
In the case of a desk stapler, or manual stapler, remove the pusher or follower block, and remove the remaining staples. Insert a pencil behind where the staples come out under the magazine and press down a few times with the pencil. Tap the hammer against the punch and the jam should clear.
How do you open an old stapler?
Set the stapler down on the table and look at the back end. There’s a small button on either the top or bottom edge. Press it to pop out the staple tray. Your stapler may also have a small piece of plastic over the tray that you’ll need to remove.
Why does my stapler keep jamming?
Originally Answered: Why do staplers jam? Cheap staples that are made of thin, softer wire and have blunt points are most likely to bend, crumple and fail to penetrate the layers of paper. Harder paper also resists the staple and causes crumpling.
How do you open a stapler?
Open the stapler. To open these, grip the base of the stapler, then pull the top of the stapler until it lifts open and the staple tray is revealed. Back load staplers usually have a button on the back, so to open these, push the button until the stapler tray pops out slightly.
