What does feed thru lugs mean?
Feed-thru lugs: 1. Always mounted opposite of the main. 2. Used on main lug or main breaker panels.
What does Main lugs only mean?
Main lug only load centers are typically applied downstream of a main circuit breaker panel and are often referred to as a sub panel. For main lug only load centers, the incoming cables are terminated on the line side of the lugs that are attached directly to the bus, no main overcurrent device exists within the panel.
What are lugs in a panel?
Main lug units are primarily used as a distribution panel where there is a main breaker upstream in the system. These panels are added when all circuit slots in the main breaker load center are full or when a remote panel is desired.
What is a pass through panel?
Designed to provide an effective airflow sealing solution when used in conjunction with pull out KVM switches or servers that may be occasionally extracted. Also, provides additional rack sealing where cables prevent solid blanking panels from being installed.
What is a sub feed lug block?
‘Sub feed’ is a doubble ‘main lug’ that allows you to daisy chain from one panel to another.
How do feed through lugs work?
The feed through lugs are located at the bottom of the first load center, and the second one is powered from there. When the main lugs above are supplied with voltage, the feed through lugs below are automatically energized because they connect to the same bus bars.
Can I use a main lug panel as a main breaker panel?
Consult your local codes to see if your panel will meet this or another requirement for proper installation. Main lug panels do not have a main breaker. Instead, the line wires run to a type of electrical connector called a lug. This type of electrical panel requires a separate disconnect.
Do subpanels need breaker?
The subpanel may be equipped with a main breaker to allow for power interruption without having to go back to the main panel, but it is not required to have a main shutoff circuit breaker, since the feeder breaker back in the main panel serves this function.
What is a sub feed lug kit?
What is a feed through meter?
each meter is new, and they have 200amps written on their sides. feeds then leave those meter can and go to panels. one goes directly into the wall to the first floor panel, the other runs up the exterior of the house and then enters into the attic where the other panel is.
