What is archive command in Cisco?

What is archive command in Cisco?

This feature was introduced into Cisco IOS Release 12.3(4), the Archive command enables the administrator to configure snapshots of the configuration files. The configuration is straightforward.

How do I enable archive on a Cisco switch?

To configure archiving, you go into global configuration mode and then enter archive mode. This is done by entering the archive command. From here, the minimum requirement to configure archiving is to enter a path to where the archive files will be stored.

What is archive in Cisco switch?

Cisco calls these snapshots ‘configuration archives’ and they are very useful as it allows you to store multiple versions of your configuration. The configuration archive can be created every time you save your running configuration or you can create one based on a time schedule, for example each 24 hours or so.

What is the Save command in Cisco?

Save the Configuration Type “copy running-config startup-config” at the command line and press return on the keyboard. This will copy the current switch configuration to the non-volatile memory, which is memory that will retain its data even without power applied to it. 3.

How do I enable TFTP on my Cisco router?

How To Configure a Cisco With TFTP

1. Install Solar Winds TFTP server on your computer.
2. Open TFTP server.
3. Connect your PC’s ethernet port to one of the four E(0) ports on the back of the router.
4. Configure the ip of your computer.
5. Open a terminal emulator and configure the session with 9600 8N1.

What is write command in Cisco?

The write commands are used to work with the current configuration. They are obsolete and have been replaced by the copy , show , and erase commands. Table 17-29 shows the correspondence between the two sets of commands.

How do I update my Cisco router?

On your router, go to Administration >> Firmware Upgrade. Browse to the location of the latest drive you just downloaded. Click Start Upgrade. Now, wait while the firmware is upgraded.

How do I TFTP a file?

Installing TFTP Client

1. Go to the Start Menu and open up the Control Panel.
2. Navigate to Programs and features and then on the left-hand side, click ‘Turn Windows features on or off’.
3. Scroll down and locate TFTP Client. Check the box. Installing TFTP Client.
4. Click OK to install the client.
5. Wait for it to complete.